Care And Maintenance; Filter Indicator; Care Index; Water Tank - Sharp KC-G60TA Operation Manual

CARE AND MAINTENANCE

FILTER INDICATOR

The filter reset Indicator light will turn on after approximately
720 hours operating. (30 days × 24 hours =720 hours)
This is a reminder to perform the maintenance described
below. After performing maintenance, reset the Filter
Indicator.

CARE INDEX

1
4
Place
1

Water Tank

2
Unit / Back Panel (Pre Filter)
3 Sensors
Humidifying Filter
4
Humidifying Tray
HEPA Filter
5
Deodorizing Filter
KC-G60TA_G50TA_G40TA.indd 11
RESET
more
3 sec.
2
3
5
2
Ref.
E-11
E-12
E-13
WATER TANK
NOTE
How to clean hard to remove dirt.
Tank Cap

UNIT / BACK PANEL

Wipe with a dry, soft cloth.
Back Panel
(Pre Filter)
Remove the dust gently with
a cleaning tool such as a
vacuum cleaner.
NOTE
How to clean hard to remove dirt.
Back Panel
1. Add a small amount of kitchen
detergent to water and soak for
about 10 minutes.
CAUTION
Do not apply excessive pressure
when scrubbing the back panel.
2. Rinse off the kitchen detergent with
clean water.
3. Completely dry the filter in a
wellventilated area.
Sensor Filter
Sensor Filter
1. Remove the Back Panel.
2. Remove the sensor filter.
3. If the sensor filter is very dirty, wash
it with water and dry it thoroughly.
E-11
Rinse the inside
with water.
Clean the inside of
the Water Tank with
a soft sponge and
the Tank Cap with
a cotton swab or
toothbrush.
Toothbrush
Sensors
2017/05/23 16:27:04