Canon MP11DX - Printing Calculator Manual

BEFORE STARTING

• Read all instructions before use.
• Remove the insulation tape and press the [RESET] button at the back of the calculator before use. (Figure .)
• Lift the tab on the back-side of the printer cover (Figure then remove the tape on the ink ribbon (Figure ).

GENERAL MAINTENANCE

• Do not use or leave the calculator under direct sunlight. Areas subject to rapid temperature changes, high humidity, dust and dirt should also be avoided.
• Use a dry cloth to clean the casing of the unit. Do not use water or detergents.
• Only use the printer when the paper roll is loaded.
• Avoid using the calculator in places where there are iron filings, as this may affect the electrical circuits of the calculator.
• Do not place anything on top of the machine, particularly on top of the printer mechanism.
• Turn the calculator off before removing the plug from the electrical outlet.
• In case of electrical fault (i.e. smoke), disconnect the plug from the electrical outlet immediately. The outlet should be installed near the equipment and should be easily accessible.

INSTALLING PRINTING PAPER

1. Lift up the paper arm (Figure ).
   
   • When inserting the paper, cut the edge of the paper as shown.
2. Place the new paper roll on the arm. The edge of the paper should be positioned as shown (Figure.)
   
   • Standard calculator paper – Width: 2-1/4" (57mm) / Diameter: 3-3/8" (86mm)
3. Insert the paper into the slit at the back of the machine as indicated. (Figure )
   
   
4. Turn the calculator on. Press the paper feed key [] to advance the paper (Figure ).
   

REPLACING THE INK RIBBON

Note: Turn power switch off.

1. Lift the tab on the back-side of the printer cover, and then remove the cover. (Figure )
   
   
2. While pinching the ribbon lock (A) in the direction of the arrow, lift ribbon spools off the shafts. Discard the old ribbon and spools. (Figure )
   
   
3. Separate the spools of new ribbon between the tape and printer head. Guide it around the four positions of the ribbon guide (B) and place the spools on the shafts. (Figure )
   
   
4. When the ribbon spools are settled, release the ribbon locks. If necessary, rotate the spools until the pegs on the botton of the spool seat themselves in the holes of the spool holder. (Figure )
   
   
5. Rotate either spool to take up any ribbon slack, making sure that the ribbon is positioned around the four ribbon guides. Replace the printer cover. (Figure )
   
   
   Use only the same type of ribbon spools.

POWER ON/OFF / PRINT ON / ITEM COUNT SELECTION SWITCH

	Turns calculator Off.
	Turns calculator On. Entries and results will appear on the display, but will not be printed out.
	Entries and results will appear on the display and will be printed out.
	Set the switch to "ITEM" to print the number of times the keys have been pressed (up to 999). The item count will be printed on the left hand side of the paper roll when the keys are pressed.

MEMORY / CURRENCY CONVERSION SELECTION SWITCH

MEMORY CALCULATION

Set the switch to "MEM" position to perform calculation using memory and basic calculation function. Entries and result will appear on the display and printout.

CURRENCY CONVERSION CALCULATION

Set the switch to "CONV" position to perform currency conversion calculation functions. Entries and result will appear on the display and printout.

• Set the switch to and enter the currency conversion rate and press or to store the current rate.
• Press or to recall the stored currency conversion rate.
• Press to convert currency figure displayed from or to the .
• Press or to convert displayed figure from to or .

*1 Specifying the Number of Decimal Places for Intermediate US Dollar Amounts. When you convert from one national currency to another, the calculator internally converts the original currency to US dollars. This conversion result is the "intermediate US dollar amount". Next, the intermediate US dollar amount is converted to the target currency. The flow of the steps of the conversions will be shown on the printout. For this type of calculation, you should use the following procedure to specify the number of decimal places for the intermediate US dollar amount. You can specify from 0 (*2) to 9 decimal places, for a floating decimal point (F). The intermediate US dollar amount is rounded off to the number of decimal places you specify.
*2 0 is displayed when F (floating point) is set for the number of decimal places. F is the initial default setting.
*3 For rates of 1 or greater, you can input up to six digits. For rates less than 1 you can input up to 8 digits, including 0 for the integer digit and leading zeros (though only 7 significant digits, counted from the left and starting with the first non-zero digit, can be specified).

DECIMAL POINT SELECTOR SWITCH

	Used for designating the decimal point position (0, 2, 3, 4, 6) for calculated results.
	+ (Add-Mode) – Addition and subtraction functions are performed with an automatic 2-digit decimal. It is convenient for currency calculations.
	F (Floating Decimal point) – All effective numbers up to 12 digits are printed or displayed.

ROUNDING SWITCH

Used for round-up [], round-off [5/4], or round-down [] to the pre-selected decimal digits in the result.

GRAND TOTAL / RATE SET SWITCH

	GRAND TOTAL When the calculations are performed with the GT switch set to "ON", the totals are accumulated in the grand total memory. Each time is pressed, the subtotal number is printed with the symbols G+. When is pressed, the intermediate grand total is printed with the symbols G. Press successively to get the grand total followed by the symbols G.
	RATE SET Set switch to "RATE SET" for setting or recalling the tax and currency rate.

OVERFLOW FUNCTION

In the following cases, when "E" is displayed, "ERR" is printed, the keyboard is electronically locked, and further operation is impossible. Press to clear the overflow. The overflow occurs when:

1. The result or the memory content exceeds 12 digits to the left of the decimal point.
2. Dividing by "0".
3. The sequential operation speed is faster than the calculation processing speed. (Buffer Register Overflow)

Electromagnetic interference or electrostatic discharge may cause the display to malfunction or the contents of the memory to be lost or altered. Should this occur, use the tip of a ball point pen (or similar sharp object) to press the [RESET] button at the back of the calculator. After resetting, be sure to set the calendar, clock, currency and tax rate again.

SPECIFICATIONS

Model Name: MP11DX-2
Power Source: AC 120V, 60Hz
Operation Temperature: 32°F to 104°F (0°C to 40°C)
Calculating Capacity: 12 digits maximum
Dimension: 12-1/64" (L) x 8-3/16" (W) x 3-5/64" (H) / 305mm (L) x 208mm (W) x 78mm (H)
Weight: 50 oz (1,480 g )
(Subject to change without notice)

REPLACING BACKUP BATTERY

Memory backup battery retains the tax rate, currency rate, clock and calendar setting, when the power is off or even when the AC cord is disconnected. Battery : 1 Lithium battery (Type: CR2032) Battery life: Backup time 2 years After replacing the back-up battery, press the [RESET] button. After resetting be sure to set the tax rate, currency rate, clock and calendar setting again.

• Risk of explosion if battery is replaced with an incorrect type. Dispose of used batteries according to the instruction.
• The socket-outlet should be installed near the equipment and should be easily accessible. In case of electrical fault (i.e. smoke), disconnect the plug from the electrical outlet immediately.

Clock & calendar function

SETTING

	Used to switch between clock or calendar mode. Pour passer du mode Horloge au mode Calendrier et vice versa.
	Used to switch between 12 or 24 hour at clock mode time setting. Pour passer du mode 12 heures au mode 24 heures et vice versa pour le réglage de l'heure.
	Used to set the date and time in calendar & clock mode. Pour régler la date et l'heure en modes Calendrier et Horloge.
	Used to switch between AM or PM at clock mode time setting. Pour passer du mode AM au mode PM et vice versa pour le réglage de l'heure.
	Used to select date format between "YYYY/MM/DD", "DD/MM/YYYY" or "MM/DD/YYYY" at calendar mode. Pour choisir le format de date: « AAAA/MM/JJ », « JJ/MM/AAAA » ou « MM/JJ/AAAA » en mode Calendrier

Note: The calendar, clock, tax and currency rate will clear if all power sources and backup battery are disconnected. In this case, please reset the settings.

Date Setting (Example: January 18 2017)

Time Setting (Example: 3: 18 pm)

Calculation examples

SETTING:

• If switches below do not match the example, please set switches as shown.

Data Printout

Item Count

Tax Calculation

	Add Tax Key – Used for adding the tax amount to the displayed figure.
	Deduct Tax Key – Used for deducting the tax amount from the displayed figure.

Cost-Sell-Margin Calculation

- Used for calculating the cost, selling price and profit margin amount. Enter the value of any 2 items to obtain the balance value item. (e.g. enter the value of the cost and the selling price to obtain the profit margin %.)

Currency Conversion Calculation

Double Check Function

SETTING:

• After selecting the setting of "Decimal","Rounding" and "GT", please keep the same setting in the process of Double Check Function in order to obtain accurate checking result.

	Used to start the Check record process. "CHE" will appear on the display.
	Used to start a Check process. The Check process compares the user input with the previous recorded operation queue. "CHE StArt" will appear on the display.

• The switches setting must match the 1 and 2 operation input. If the switches do not match, the below message will print out.
  * ••001•• – Decimal point setting is different
  * ••002•• – Rounding setting is different
• This calculator has a 100 step of operation queue, which is useful for check process. If out of the operation queue, it is not allowed to enter into the Double Check function and "E CHE St FULL" message will appear on the display.
• In first input press key to end the calcualtion for checking. will print out.
  In second input press key to abort the check process. "••000••" will print out.

Overflow

© CANON ELECTRONIC BUSINESS MACHINES (H.K.) CO., LTD. 2017