Figure 42 Connecting the PSR150-D
Connecting the PSR150-D to a –54 VDC output RPS
To connect the PSR150-D to a –54 VDC output RPS:
Unpack the RPS power cord, identify the plug for connecting to the power supply, correctly orient
1.
the plug with the power receptacle on the power supply, and insert the plug into the receptacle (see
callout 1 in
The receptacle is foolproof. If you cannot insert the plug into the receptacle, re-orient the plug rather
2.
than use excessive force to push it in.
Tighten the screws on the plug with a flat-blade screwdriver to secure the plug in the power
3.
receptacle (see callout 2 in
Connect the other end of the power cord to the RPS.
4.
Figure
42).
Figure
42).
32