Table of Contents
Advertisement
NOTE
• To run the ceramic heater continuously, do
not set the timer or set the timer to '0H'.
• All operating modes can be adjusted at any
time after the timer is set.
• The ceramic heater will automatically stop
operation and switch to standby once the set
time has elapsed.
CHILD LOCK
When the Child Lock is engaged, the buttons
on the control panel are locked from use.
1. To turn on Child Lock, touch and hold the
button until a beep sounds and the
illuminates on the LED display panel.
2. To cancel, repeat step 1 until the child lock
icon no longer illuminates on the LED
display panel.
OSCILLATION
The ceramic heater can oscillate automatically
left and right to 40 degrees. Oscillation can be
set on any operating MODE.
To activate oscillation, touch the
once. The ceramic heater will move left and
right continuously.
To set the orientation of your ceramic heater,
touch the
button again. The ceramic heater
will stop oscillating and stay at your chosen
position.
TILT
The Breville ceramic heaters come with
tilting hinges that allow you to manually tilt
the housing up to 30 degrees for better heat
flow directional control. Simply tilt the heater
housing to the angle preferred.
REMOTE CONTROL
The ceramic heater come with a remote
control. This remote control features the same
controls as on the control panel and can be
used the same way.
Fig. 1
button
To check and/or to replace the battery, open
up the battery compartment at the back of the
remote by forming a good grip of the remote,
pushing the small arched groove to the right
and simultaneously pushing out the battery
compartment cover by pushing the rectangular
groove outwards. Insert the battery paying
attention to the polarity (+ and -) (Fig 2).
To avoid misplacing
your remote control,
the magnetic
back allows you to
conveniently attach
to the right-hand side
of the ceramic heater
frame as indicated
(Fig 1).
The remote control
includes 1 x CR2032
3V Lithium battery.
This Lithium battery
is protected by an
isolating slip. Before
first using the remote
control, remove the
battery isolating slip
by pulling the slip
outwards away from
the remote control.
BACK OF REMOTE
Fig. 2
13
Advertisement
Table of Contents
