Table of Contents
Advertisement
3 MAINTENANCE OF FREEZER
3.1 Cleaning
•
Clean dust behind the freezer and on the ground to improve the cooling effect and
energy saving.
•
Check the door gasket regularly to make sure there is no debris. Clean the door gasket
with a soft cloth dampened with soapy water or diluted detergent.
•
Clean the interior of the freezer regularly to avoid odor.
•
Please turn off the power before cleaning interior, remove all food, shelves, drawers, etc.
•
Use a soft cloth or sponge to clean the inside of the freezer, with two tablespoons of
baking soda and a quart of warm water. Then rinse with water and wipe clean. After
cleaning, open the door and let it dry naturally before turning on the power.
•
For areas that are difficult to clean (such as narrow gaps or corners), it is recommended
to wipe them regularly with a soft rag, soft brush, etc. to ensure no contaminants or
bacteria accumulate in these areas.
•
Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause odors in
the interior of the freezer or contaminate food.
•
Clean the baskets with a soft cloth dampened with soapy water or diluted detergent. Then
rinse with water and dry with a soft cloth or naturally.
•
Wipe the outer surface of the freezer with a soft cloth dampened with soapy water,
detergent, etc., and then wipe dry.
•
Do not use hard brushes, clean steel balls, wire brushes, abrasives (such as toothpastes),
organic solvents (such as alcohol, acetone, banana oil, etc.), boiling water, acid or alkaline
items, which may damage the cooler surface and interior. Boiling water and organic
solvents such as benzene may deform or damage plastic parts.
•
Do not rinse directly with water or other liquids during cleaning to avoid short circuits or
damage to the electrical insulation.
3.2 Defrost
•
Manually defrost the freezer. Disconnect the plug from the wall socket, open the door
and remove all contents and shelving baskets before defrosting. open the outflow hole
and drainage hole (and place water container at the outflow hole)
remove the frost by a plastic scraper, or let the temperature rise naturally until the frost
melts. Then wipe away the remaining ice and water, and plug in the freezer.
3.3 Stop Using
Power failure: Food can usually be preserved for a couple of hours in case of power failure. It
is recommended to reduce the frequency of opening the door and to not put fresh food into
the freezer.
Long-time nonuse: Please unplug unused freezer for cleaning. Keep the door open to avoid
odor.
Moving: Do not turn upside or shake the freezer, the carrying angle can not be greater than
45°.
Do not hold the door and hinge when moving this unit.
Please unplug the freezer for defrost and cleaning.
Do not use other mechanical devices or other means to accelerate the
defrosting process except those recommended by the manufacturer.
Do not damage the refrigerant circuit.
Continuous operation is recommended when the freezer is started. To
prevent affecting the freezer's service life, please do not stop the freezer
under normal circumstances.
7
It is recommended to
;
Advertisement
Table of Contents
