Table of Contents
Advertisement
Make sure you save your password setting and that you
highlight * * EXIT AND SAVE * * when you leave
the Setup program.
4. After you exit Setup, you see this message:
TURN OFF POWER AND CORRECT JUMPER
SETTING TO ENABLE PASSWORD CHECKING
5. Remove the Reference diskette, turn off the computer, and
follow the instructions under "Changing Jumper Settings"
in Appendix A to enable the password function by setting
jumper JP9 to position 1-2.
6. If you do not have a hard disk, insert the Startup diskette in
drive A. Turn on the computer. You see the key prompt
(
). If you enabled network server mode and did not
insert a diskette, you do not see the key prompt. Enter your
new password to access the system. (See "Using the Power-
on Password" in Chapter 3.)
Keyboard Problems
If you are having trouble with the keyboard, check the
following:
1. If the screen displays a keyboard error when you turn on or
reset the computer, make sure the keyboard is securely
connected to the computer. See "Connecting the
Keyboard" in Chapter 1 for instructions.
Troubleshooting
B-8
Advertisement
Table of Contents
