Table of Contents
Advertisement
4. Reach behind the drive and gently push it out through the
front of the bay; then pull it out of the slot.
5. Once you have removed the drive, replace the faceplate by
inserting one side of the plate, then gently pressing on the
other side until it snaps into place.
6. Replace the drive mounting bracket and reconnect the cables.
See page 5-7 for instructions.
Post-installation Procedures
After you install or remove your drive(s) and replace the cover
on your computer, you need to run the SETUP program to
define your new drive configuration. See Chapter 2 for
instructions.
5-22
Installing and Removing Drives
Advertisement
Table of Contents
