Stopping A Command Or Program - Epson ActionPC 6000 User Manual

To insert a diskette into a 5.25-inch drive, hold the diskette with
the label facing up and the read/ write slot leading into the
drive. When the disk is completely in the drive, turn down the
latch to secure the diskette in the drive.
When you want to remove the diskette, make sure the drive
light is offi then press the release button or turn the latch.
Remove the diskette and store it properly.
Caution
Never remove a diskette, reset the computer, or turn it off
while a diskette drive light is on. You could lose data. Also,
remove all diskettes before you turn off the computer.

Stopping a Command or Program

You may sometimes need to stop a command or program while
it is running. If you want to stop a DOS or DOS application
program command, try one of the following:
Press P a u s e
Press Ctrl C
Press Ctrl Break.
If these methods do not work, you may need to reset the
computer as described below. Do not turn off the computer to
exit a program or stop a command unless you have to, because
the computer erases any data you did not save.
Using Your Computer
3-8