Turning Off The Computer - Epson ActionDesk 4000 User Manual

5. If necessary, use the controls on your monitor to adjust the
brightness
characters on the screen. If your monitor has horizontal and
vertical hold controls, you may need to use them to
stabilize the display.
if your system is configured to automatically load a program
(such as Windows or
the first menu or screen display of that program. If not, you
may see the operating system prompt, such as c : \ > or
A:\ >.
If there is no operating system installed on your computer,
you see an error message. Ignore the message for now; once
you install the operating system, you will not see this
message.
Now you need to run the SETUP program to make sure your
computer is configured properly- First turn off the computer, as
described below, then see Chapter 2 for instructions. When you
finish running SETUP, be sure to see "Post-SETUP Procedures"
on page 2-16 for guidelines on what you need to do next.

Turning Off the Computer

Whenever you turn off your system, follow these steps:
1. Save your data and exit any application program you are
using.
2. Check the hard disk drive light and the diskette drive light(s)
to make sure they are not
if a drive light is on, because you can damage the drive or
lose data.
3. Remove any diskette(s) from the diskette drive(s).
until you can easily see the
and contrast
word processing program), you see
a
on.
Do not turn off the computer
Setting Up Your System 1-9