Sony BC-WF1000X Service Manual
Sony BC-WF1000X Service Manual

Sony BC-WF1000X Service Manual

Wireless noise canceling stereo headset and charging case

Advertisement

SERVICE MANUAL
Ver. 1.0 2017.08
• All of the units included in the WF-1000X
(WF-1000XL/WF-1000XR/BC-WF1000X)
are required to repairing of this unit. Check
in advance that you have all of the units.
COMPONENT MODEL NAME (WF-1000X)
Wireless noise canceling
stereo headset
Charging case
General
Transmission range (A2DP):
Communication system: BLUETOOTH
Specification version 4.1
Output: BLUETOOTH Specification Power
Included items:
Class 1
Maximum communication range: Line of
1)
sight approx. 10 m (30 ft)
Frequency band: 2.4 GHz band (2.4000 GHz
- 2.4835 GHz)
(AEP, UK)
Operating frequency:
BLUETOOTH 2,400 MHz - 2,483.5 MHz
NFC 13.56 MHz
Maximum output power:
BLUETOOTH < 20.0 dBm
NFC < 60 dBμA/m at 10 m
1)
The actual range will vary depending on
(CH)
factors such as obstacles between
devices, magnetic fields around a
microwave oven, static electricity,
reception sensitivity, antenna's
performance, operating system, software
application, etc.
Compatible BLUETOOTH profiles
2)
:
2)
BLUETOOTH standard profiles indicate the
A2DP (Advanced Audio Distribution
purpose of BLUETOOTH communications
Profile)
between devices.
AVRCP (Audio Video Remote Control
3)
Codec: Audio signal compression and
Profile)
conversion format
HFP (Hands-free Profile)
4)
Subband Codec
HSP (Headset Profile)
5)
Advanced Audio Coding
3)
4)
5)
Supported Codec
: SBC
, AAC
Supported content protection method:
SCMS-T
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
注意
如果电池更换不当会有爆炸危险
只能用同样类型或等效类型的电池来更换
9-896-429-01
2017H33-1
Sony Video & Sound Products Inc.
©
2017.08
Photo: WF-1000XL
(L-ch)
L-ch
WF-1000XL
R-ch
WF-1000XR
BC-WF1000X
SPECIFICATIONS
Wireless noise
20 Hz - 2 0,000 Hz (Sampling fr equency
canceling stereo
44.1 kHz)
headset
Power source:
Wireless noise canceling stereo headset
DC 3.7 V: Built-in lithium-ion
(1)
rechargeable battery
Micro-USB cable (approx. 50 cm (19 3/4
DC 5 V: When charged using USB
in.)) (1)
Mass: Approx. 6.8 g (0.24 oz) (Headset)
Charging case (1)
Approx. 70 g (2.5 oz) (Charging case)
Long Hybrid silicone rubber earbuds
Operating temperature: 0 °C to 40 °C (32 °F
(SS/S/M/L 2 each)
to 104 °F)
Triple-comfort earbuds (S/M/L 2 each)
Rated power consumption (AEP, UK):
Fitting supporters (M/L 2 each)
1 W (Headset), 3 W (Charging case)
Reference Guide (1)
Operating Instructions (1)
Usage hours:
Other documents (1 set)
When connecting via the BLUETOOTH
device
Music playback time:
Max. 3 hours (NC ON), Max. 3 hours
(NC OFF)
Communication time:
Max. 3.5 hours
Standby time:
Max. 8 hours (NC ON), Max. 35 hours
(NC OFF)
Note: Usage hours may be shorter
depending on the Codec and the
conditions of use.
Charging time:
Approx. 1.5 hours
(About 70 minutes of music playback is
possible after 15 minutes charging.)
(Headset)
Approx. 3 hours (Charging case)
Note: Charging hours may be different
depending on the conditions of use.
WIRELESS NOISE CANCELING STEREO HEADSET
WF-1000X
BC-WF1000X/WF-1000XL/1000XR
Photo: BC-WF1000X
Photo: WF-1000XR
(R-ch)
Charging temperature: 5 °C to 35 °C (41 °F to
95 °F)
Receiver
Type: Closed, Dynamic
Driver unit: 6 mm
Microphone
Type: Electret condenser
Directivity: Omni directional
Effective frequency range: 50 Hz - 8,000 Hz
System requirements
for battery charge using
USB
(As of August 2017)
Personal Computer with pre-installed with
any of the following operating systems and
USB port:
Operating Systems
(when using Windows)
Windows
®
10 Home / Windows
Windows
®
8.1 / Windows
Windows
®
8 / Windows
Windows
®
7
Home Basic / Home Premium /
Professional / Ultimate
(when using Mac)
Mac OS X (version.10.9 or later)
Design and specifications are subject to
change without notice.
US Model
Canadian Model
AEP Model
UK Model
E Model
Australian Model
Chinese Model
Tourist Model
The Bluetooth® word mark and logos are
registered trademarks owned by the
Bluetooth SIG, Inc. and any use of such
marks by Sony Corporation is under license.
The N-Mark is a trademark or registered
trademark of NFC Forum, Inc. in the United
States and in other countries.
Windows is a registered trademark or
trademark of Microsoft Corporation in the
United States and/or other countries.
Mac, OS X, iPhone and iPod touch are
trademarks of Apple Inc., registered in the
U.S. and other countries.
"Made for iPod" and "Made for iPhone" mean
that an electronic accessory has been
designed to connect specifically to iPod or
iPhone, respectively, and has been certified
by the developer to meet Apple performance
standards. Apple is not responsible for the
operation of this device or its compliance
with safety and regulatory standards. Please
note that the use of this accessory with iPod
or iPhone may affect wireless performance.
®
10 Pro
®
8.1 Pro
Android is a trademark of Google Inc.
®
8 Pro
Other trademarks and trade names are those
of their respective owners.
WF-1000X/1000XL/1000XR
BC-WF1000X
CHARGING CASE

Advertisement

Table of Contents
loading

Summary of Contents for Sony BC-WF1000X

  • Page 1 Communication system: BLUETOOTH 44.1 kHz) Bluetooth SIG, Inc. and any use of such Specification version 4.1 Receiver headset marks by Sony Corporation is under license. Output: BLUETOOTH Specification Power Included items: Type: Closed, Dynamic The N-Mark is a trademark or registered Class 1...
  • Page 2: Section 1 Servicing Notes

    4. Playback the audio from the device and check that the sound is outputted from WF-1000XL (L-ch) and WF-1000XR (R-ch). 5. Touch the N-Mark part of the BC-WF1000X (charging case) with N-Mark of the device again to disconnect the connection.
  • Page 3 3. Open the lid of the BC-WF1000X (charging case), insert WF- 3. While the power is off, press the buttons of WF-1000XL (L- 1000XL (L-ch) and WF-1000XR (R-ch), and check that the ch) and WF-1000XR (R-ch) simultaneously for more than 15 lamp is lit as shown below fi...
  • Page 4 The WF-1000XL (L-ch) will be replaced in the state of the fi nished product. Cannot repairing and replacing of each component parts. Also, it is necessary to disassemble the bottom of the BC-WF1000X (charging case) and replace it at the same time.
  • Page 5 (Charging case) The WF-1000XR (R-ch) will be replaced in the state of the fi nished The BC-WF1000X (charging case) will be replaced in the state of product. Cannot repairing and replacing of each component parts. the fi nished product. Cannot repairing and replacing of each com- When replacing the WF-1000XR (R-ch), perform the following ponent parts.
  • Page 6 Note 5: The display method of Bluetooth address may be different de- pending on Windows OS. 4. Write the Bluetooth information to the BC-WF1000X (charg- ing case) using smartphone that installed the NFC Tag Data Writing Application.
  • Page 7 BLUETOOTH INFORMATION WRITING METHOD 3. Transfer the NFC Tag Data Writing Application to the smart- phone. When the BC-WF1000X (charging case) is replaced, the writing of 4. When tapping the “Settings” → “Security” on the screen of the Bluetooth information is necessary.
  • Page 8 Write the NFC tag data (Bluetooth information) to the NFC mod- 4. Tap the “Write” on the screen of the smartphone. ule in the BC-WF1000X (charging case). Procedure: 1. Check the Bluetooth address (BD_ADDR). 1 Press the [1] button of the WF-1000XL (L-ch) for more than 7 seconds to pairing state, and connect it to the PC with Bluetooth function.
  • Page 9 8. Touch the N-mark part of the smartphone to the N-mark part of and tap the “Write” on the screen of the smartphone. the BC-WF1000X (charging case). 9. Check that “Success!” is displayed on the screen of the smart- phone.
  • Page 10 4. When “MODE” on the screen of the smartphone is “0000 depending on Windows OS. (Read-only)”, execute the writing of the NFC tag data again after replacing the BC-WF1000X (charging case). 2. Turn on the NFC function of the smartphone. (When “MODE” on the screen of the smartphone is “0000 (Read-only)”, the writing of the NFC tag data cannot execute)
  • Page 11 Bluetooth manual con- Bluetooth manual connec- NFC one touch connection Factor NFC tag data check nection check by user tion check by servicing check with smartphone WF-1000XL (L-ch) ― defect BC-WF1000X (charging case) defect NFC tag data writing failure 4 Smartphone...
  • Page 12: Section 2 Disassembly

    – – rear side BC-WF1000X (charging case) 6 Insert a flathead screwdriver in between the CRADLE NFC board and plate (bottom), and peel off the sheet (NFC). Note 4: Be careful so that you do not damage the plate (bottom).
  • Page 13: Section 3 Exploded View

    Note 3: For information about sizes other than size M, refer to “AC- CESSORIES” on page 14. Note 4: When replacing the charging case (BC-WF1000X) (Ref. No. BC1), make sure to refer to “REPAIRING AND REPLAC- ING OF THE BC-WF1000X (Charging case)” on page 5.
  • Page 14: Section 4 Accessories

    WF-1000X SECTION 4 ACCESSORIES Ref. No. Part No. Description Remark 4-724-042-12 MANUAL, INSTRUCTION (Operating Instructions) (Except CH) 4-724-042-21 MANUAL, INSTRUCTION (Operating Instructions) Micro-USB cable (approx. 50 cm) (1) (CH) 4-724-043-11 GUIDE, REFERENCE (ENGLISH, SPANISH, FRENCH) (US, CND, LA) 4-724-043-21 GUIDE, REFERENCE (ENGLISH, RUSSIAN, KOREAN) (E, AUS, JE, RU) 4-724-043-31 GUIDE, REFERENCE (SIMPLIFIED CHINESE)
  • Page 15 WF-1000X MEMO...
  • Page 16: Revision History

    WF-1000X REVISION HISTORY Ver. Date Description of Revision 2017.08...

This manual is also suitable for:

Wf-1000xlWf-1000xr

Table of Contents