Step Two: Allocate Port Licences; Step Two: Connect To Ethernet Port A - Cisco TelePresence VCR MSE 8220 Getting Started

Figure 3: Closing the retaining latches on the front of a blade

Step two: Allocate port licences

Port licenses must be allocated to the VCR MSE 8220 from the Supervisor's
page. Refer to the online help for assistance.
licenses

Step two: Connect to Ethernet Port A

Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a
hub, to minimize interference from other devices on the network). The Ethernet
port is a 10/100/1000 Mbps auto-sensing connection.
Only connect to Ethernet Port B if you need to connect the VCR MSE
i
8220 to a second subnet.
Do not connect Ethernet Port A and Ethernet Port B to the same subnet.
!
Installing the VCR MSE 8220
Port
8