Installing The Vcr Mse 8220; Step One: Install The Vcr Mse 8220 Into The Mse 8000 Chassis - Cisco TelePresence VCR MSE 8220 Getting Started

Installing the VCR MSE 8220

IMPORTANT
you must read the safety information for the MSE 8000 chassis at:
http://www.cisco.com/go/telepresence/safety
Although blades are hot-swappable parts, you must only remove one
!
blade at any time. Remove the power from the MSE 8000, if you need to
remove more than one blade at a time.
Before hot-swapping a blade, shut down the blade using the web interface.
!
Do not shut down a blade during a software upgrade or if the blade is
processing.
For information about powering the MSE 8000, refer to the Getting Started Guide on
http://www.tandberg.com/support/video-conferencing-documentation.jsp).

Step one: Install the VCR MSE 8220 into the MSE 8000 chassis

You must install either a blade or a blanking blade in each of the ten
!
positions in the chassis.
The Supervisor blade must be installed into slot 1 of the MSE 8000
!
chassis.
1 Remove the blade or blanking blade from the slot into which you are going to
install the VCR MSE 8220:
i Using a No.1 Phillips screwdriver, loosen the screws in the retaining latches
with an anti-clockwise quarter turn.
ii Open both retaining latches on the front of the blade or blanking blade.
When open, a retaining latch is at a 90
the blade.
iii Slide out the blade or blanking blade.
2 Open both retaining latches on the front of the VCR MSE 8220. When open, a
retaining latch is at a 90
3 Slide the VCR MSE 8220 into the blade slot (as shown in Figure 2) until it stops.
: Before installing the VCR MSE 8220 into the MSE 8000,
angle perpendicular to the front of the blade.
°
Installing the VCR MSE 8220
.
angle perpendicular to the front of
°
6