Advertisement
®
CARE & CLEANING
The main components of the Encore ESP can be removed from the grinder for cleaning or maintenance.
REMOVING AND REINSTALLING THE HOPPER
The hopper may be removed for cleaning or maintenance of the burrs.
TO REMOVE:
1.
Remove all coffee beans from the hopper and grind any remaining beans through using either the On/Off switch or the pulse button.
the grinder from the power outlet before removing the hopper.
2.
Rotate the hopper completely counterclockwise so that the grind setting indicator is aligned with the triangle near
grind setting 40.
3.
Lift the hopper off of the grinder.
Note: The hopper gasket may come off with the hopper. If it does, install it on the ring burr by placing it thick side down within the plastic rim on top of the
ring burr to ensure that it is not lost during cleaning.
TO REINSTALL:
1.
Check that the hopper gasket, ring burr, and cone burr are all installed properly.
2.
Grip the two grind adjustment tabs and ensure that the grind adjustment ring is rotated fully counterclockwise.
3.
Align the grind setting indicator on the hopper with the triangle near grind setting 40. Push down on the hopper and rotate it clockwise until it
starts to click.
Caution: Do not put the hopper, hopper lid or grounds bin in the dishwasher. Hand wash only. Do not
immerse the grinder housing in water. Do NOT wash the burrs with water, or they will rust.
January 2023 (v1.0)
ENCORE ESP™ OPERATIONS MANUAL
Unplug
7
Advertisement
