Advertisement
®
OPERATION
INITIAL SETUP
1.
Remove the contents from the packaging and hand-wash the hopper lid (1), bean hopper (2), dosing cup (9), and grounds bin
soapy water. Let air dry.
2.
To install the hopper, align the silver grind setting indicator
clockwise into place. The grinder will not start without the hopper
3.
If grinding for espresso, insert the dosing cup base
4.
To install the on/off knob (11), align it with the stem of the switch on the right side of the unit and press into place. Use either the on/off knob or
the pulse button
(7)
to begin grinding.
*If there is difficulty in installing the hopper: Ensure that the ring burr
counterclockwise using the adjustment ring tabs
When grinding into the grounds bin, coffee tends to mound up in the center. To prevent clogging, empty the grounds before they reach the max fill line.
RECOMMENDED INITIAL GRIND SETTINGS
The Encore ESP has a unique adjustment system that is divided into two parts: the espresso range (settings 1-20) and the filter coffee range (settings
21-40). When brewing espresso, very small changes to the grind size are needed to fine-tune the perfect espresso shot. The espresso range of the Encore
ESP's adjustment system allows for these precise adjustments, meaning each grind setting from 1-20 will only change the grind size by small amounts
between settings.
More information can be found on dialing in espresso shots in our brew guides at
the finest espresso to the coarsest cold brew in just 40 clicks, adjustments in the filter coffee range (settings 21-40) result in relatively larger changes to
the grind size from setting to setting.
Below are suggested starting points for what grind settings to use for common brew methods. Coarser or finer grinding may be needed depending on
recipe requirements and taste preference.
Suggested Setting
Note: The espresso grind setting above is based on a medium roast and a dose of 18g of coffee. For darker roasts, or larger doses, set the grinder to a
higher number. For lighter roasts, or smaller doses, set the grinder to a smaller number.
January 2023 (v1.0)
ENCORE ESP™ OPERATIONS MANUAL
Do not wash the ring burr (5) in water or it will rust.
(10)
(14)
for the hopper to be installed.
More information can be found on this in our brew guides at
Espresso
AeroPress
15
22
(3)
with the triangle near grind setting 40 (6). Press the hopper down and twist
installed.*
and dosing cup (9). If grinding for filter brewing, insert the grounds bin (19).
(5)
is fully seated in place. The grind adjustment ring
Hario V60
Automatic
Brewer
25
28
(13)
must be rotated fully
Baratza.com. In order for the grind range to span from
Baratza.com.
Chemex
30
(19)
in warm,
French
Press
32
5
Advertisement
