Eject The Memory Card; Write Text; Traditional Text Input - Nokia E51 User Manual

To change the name of the memory card, select
Memory card name.
You can protect a memory card with a password to prevent
unauthorised access. To set a password, select
Set password. The password can be up to eight characters
long and is case-sensitive. The password is stored in your
device. You do not need to enter it again while you use the
memory card in the same device. If you use the memory
card in another device, you are asked for the password.
Not all memory cards support password protection.
To remove the memory card password, select
Remove password. When you remove the password, the
data on the memory card is not protected against
unauthorised use.
To open a locked memory card, select
memory card. Enter the password.

Eject the memory card

Important: Do not remove the memory card in the
middle of an operation when the card is being accessed.
Removing the card in the middle of an operation may
damage the memory card as well as the device, and data
stored on the card may be corrupted.
1. Press the power key briefly, and select
memory card.
2. Press the release button and slide off the back cover.
3. Press the end of the memory card to release it from the
memory card slot.
4. Close the back cover.
28

Write text

Options
>
The input methods provided in the device may vary
Options
according to different sales markets.
>

Traditional text input

are writing text using traditional text input.
Options
>
indicates that the first letter of the sentence is written in
uppercase and all the other letters are automatically
written in lowercase.
To write text with the keypad, press a number key 2-9
Options Unlock
>
repeatedly until the desired character appears. There are
more characters available for a number key than are
printed on the key. If the next letter is located on the same
key as the present one, wait until the cursor appears, and
enter the letter.
To insert a number, press and hold the number key.
To switch between the upper and lower case mode and
the number mode, press #.
To erase a character, press the backspace key. Press and
Remove
hold the backspace key to erase more than one character.
To access the most common punctuation marks, press the
1 key. Press 1 repeatedly to reach the desired punctuation
mark.
To add special characters, press *. Scroll to the desired
character and press the scroll key.
is shown on the top right of the display when you
and indicate the selected case.
indicates the number mode.