Table of Contents
Advertisement
Operation Tips
The following tips will help you safely and effec-
tively operate your bandsaw, and help you get the
maximum life out of your saw blades.
Tips for cutting:
•
Use work stop to quickly and accurately cut
multiple pieces of stock to the same length.
•
Clamp workpiece firmly in the vise jaws to
ensure a straight cut through the material.
•
Allow blade to reach full speed before engag-
ing workpiece. Never start a cut with the
blade in contact with the workpiece, and do
not start a cut on a sharp edge.
•
Chips should be curled and silvery. If the
chips are thin and powder-like, increase your
feed rate.
•
Burned chips indicate a need to reduce your
blade speed.
•
Wait until blade has completely stopped
before removing workpiece from vise. Avoid
touching the cut end—it could be very hot!
•
Support long pieces so they will not fall when
cut. Flag long ends to alert passers-by of
potential danger.
•
Adjust upper blade guides as close as pos-
sible to workpiece to minimize side-to-side
blade movement.
•
Use coolant when possible to increase blade
life.
Loosen blade tension at the end of each day
to prolong blade life.
Model G0592 (Mfd. Since 01/23)
Workpiece
Inspection
Before cutting, inspect the material for any of
the following conditions and take the neces-
sary precautions:
•
Small or Thin Workpieces: Small or thin
workpieces may be damaged during cut-
ting—avoid cutting these workpieces if possi-
ble. If you must cut a small or thin workpiece,
attach it to or clamp it between larger scrap
pieces that will both support the workpiece
through the cut. Some thin sheet metals will
not withstand the forces from this bandsaw
during cutting; instead, use a shear, nibblers,
or sheet metal nippers to cut these pieces.
Unstable Workpieces: Workpieces that can-
•
not be properly supported or stabilized with
the vise should not be cut on this bandsaw.
Examples are chains, cables, workpieces
with internal or built-in moving or rotating
parts, etc.
Material Hardness: Always factor in the hard-
•
ness of the metal before cutting it. Hardened
metals will take longer to cut, may require
lubrication, and may require a different type
of blade in order to efficiently cut them.
Tanks, Cylinders, Containers, Valves,
•
Etc.: Cutting into containers that are pres-
surized or contain gases or liquids can cause
explosions, fires, caustic burns, or machine
damage. Avoid cutting any of these types of
containers unless you have verified that the
container is empty and it can be properly sup-
ported during a cut.
•
Magnesium: Pure magnesium burns easily.
Cutting magnesium with a dull blade can cre-
ate enough friction to ignite the small mag-
nesium chips. Avoid cutting magnesium, if
possible.
-23-
Advertisement
Table of Contents
