Page 2
Important! It is essential that you read the instructions in this manual before assembling, operating and maintaining the product. Subject to technical modifications.
Page 3
Battery port Blade release lever On/off switch Handle, insulated gripping surface Belt clip hole Belt clip mount screw hole LED light Variable speed dial Locking clamp Sanding pad Sanding paper Segment saw blade Wood blade Belt clip Screw...
L1830R-X5 A18FB5 Do not use compressed air to blow dust or debris. This practice is Use AEG 18V battery and charger only dangerous and can cause dirt and grit to be blasted into someone’s eyes, causing serious injury. Ambient temperature range for product during operation is between WARNING! Read all safety warnings, instructions, 0°C and 40°C.
Switch the product off immediately if the accessory stalls! Do ● Always work in correct posture, keep proper footing and not switch the device on again while the accessory is stalled, as balance at all times.. doing so could trigger a sudden recoil with a high reactive force. Determine why the accessory stalled and rectify this, paying heed to RISK REDUCTION the safety instructions.
Use only AEG accessories and AEG spare parts. Should components need to be replaced which have not been described, No-load speed please contact one of our AEG service agents (see our list of guarantee/service addresses). If needed, an exploded view of the product can be ordered. Please Voltage state the Article No.
Page 24
Techtronic Industries Australia Pty Ltd 31 Gilby Road, Mount Waverley, VIC, 3149, Australia Techtronic Industries N.Z. Limited Unit C, 70 Business Parade South, AEG is a registered trade mark used under Highbrook, Auckland 2013, New Zealand license from AB Electrolux (publ). 961096791-01A...