List Of Ftp Files And Commands Supported By The Print Server - NETGEAR PS101 Reference Manual

NetGear Print Server Manual

List of FTP Files and Commands Supported by the Print Server

Table FTP Files in the Directory lists the file names that appear in the directory.
FTP Files in the Directory
File Name Purpose
CONFIG Configuration file
PSINF Device information
DEFAULTC Reset device to default configuration Read
RESET Reset device
PASSRESET Clear password
SETIP Save current IP address
Table FTP Commands lists the case-sensitive commands that are implemented. When a command
requires a parameter, the parameter is shown in italics.
FTP Commands
Command Function
dir Lists files as shown in table FTP Files in the Directory.
get FILENAME Retrieves a file. The only files that can be retrieved are CONFIG and PSINF.
get RESET Resets the print server and terminates the current connection.
get
Clears the password.
PASSRESET
Sets the current IP address as a static IP address.
get SETIP To avoid an address conflict, do not use this command if a DHCP server assigned the IP address to the print
server.
Copies the CONFIG file to the print server, overwriting the existing CONFIG file. After using this command to
put CONFIG write a new configuration file, use the get RESET command; all LEDs should turn on and then off while the
print server is resetting.
put Copies the password file to the print server and gives it a new password. Passwords can be up to 19 bytes in
PASSWORD length.
put filename Ln Copies the filename file to the printer connected to n port and prints the file.
quit Terminates the current FTP session.
Other FTP commands cannot be used, and they return an Invalid Command error message.
Mode
Read/Write
Read
Read
Read
Read
66