NETGEAR PS101 Reference Manual page 119

NetGear Print Server Manual
Channel No
Network Type
Link Info Button
WEP Disabled/
Enabled
64 Bit
128 Bit
To
communicate in "802.11 Ad-hoc" or "Ad hoc" mode, all Wireless stations MUST
same Channel number.
use the
If using "802.11 Ad-hoc" or "Ad-hoc" mode, select the value you wish to use on your Wireless
LAN.
If using "Infrastructure" mode, the Channel is selected automatically, to match the Channel
used by the Access Point.
If you experience interference (shown by lost connections and/or slow data transfers) you may
need to experiment with different channels to see which is the best.
Select the correct value for your Wireless LAN.
802.11 Ad-hoc mode is used when there is no Wireless Access Point, and each Wireless
station communicates directly with other Wireless stations. This is the current standard.
Ad-hoc mode is used when there is no Wireless Access Point, and each Wireless station
communicates directly with other Wireless stations. This is the older standard.
Infrastructure mode is used when each Wireless station connects to the Wireless Access
point. This also provides access to the wired LAN.
This will display information about the current wireless connection. See below for details.
If Disabled (default), data is NOT encrypted before being transmitted.
If Enabled, you must provide either the 64 Bit key table or the 128 Bit keys, as described
below. The key is used to encrypt the data before transmission.
If selected, data is encrypted, using the default key, before being transmitted. The receiving
station must be set to 64 Bit Encryption, and have the same Key value in the same position
in its key table. Otherwise, it will not be able to decrypt the data.
Default Key - select the key you wish to be the default. Transmitted data is ALWAYS
encrypted using the Default Key; the other Keys are for decryption only.
Key Table:
This table is used when Encrypting and Decrypting data. All stations, including this Access
Point, always transmit data encrypted using their default key. The key number (1, 2, 3, 4) is
also transmitted. The receiving station will use the key number (1, 2, 3, 4) to determine which
key value to use for decryption. If the key value does not match the transmitting station,
decryption will fail.
The easiest way to ensure there are no problems is to have every Station, including the
Access Point, use the same key table (all entries identical). Then, it does not matter which key
is used as the default key.
If selected, data is encrypted using the key before being transmitted. The receiving station
must be set to use 128 Bit Encryption, and have the same Key value. Otherwise, it will not be
able to decrypt the data.
110