Table of Contents
Advertisement
- Insert the plug into the power socket.
- Activate the main switch A; the mixer will
automatically start working in SP1 while in SP2
it will be necessary to activate the two mixers
through the appropriate switches E1 and E2.
Attention
Not all products are equally sensitive to nUVA
rays and therefore it is possible that some,
subjected to prolonged irradiation over time,
may undergo changes in colour.
In this case it is necessary to dose the
irradiation considering that in 4 hours of
exposure there is a bactericidal effect of 99%.
-Activate the freezing mode using switch B with
the snowflake symbol (fig. 21).
Fig. 26
NOTE: in SP2 there are two buttons for
freezing mode, B1 for the left tank and B2
for the right one.
NOTE: if you wish to switch from FREEZING
mode to NIGHT mode (DEFROST), simply set
the position with the drop symbol on key B (Fig.
21)
- The product is ready when the
piggy bank symbol, indicated by the
arrow on the display image, stops
flashing.
- If the product does not have the desired
consistency, it is necessary to set switch B to
position 0, adjust the consistency as desired
(fig. 25) and restart the cycle from phase A by
positioning switch B back to position
SNOWFLAKE (chapter 9).
- Once the product has reached the desired
consistency, to dispense, place the glass under
the tap and pull the lever as shown in figure 26.
Emission date: July, 2021
Revision: 2
Pag. : 18/28
Advertisement
Table of Contents
