Step 3: Checking The Installation; Step 4: Connecting Devices To The Switch - NETGEAR ProSafe GS110TP Hardware Installation Manual

Step 3: Checking the Installation

Before applying power to the switch, perform the following:
• Inspect the equipment thoroughly.
• Verify that all cables are installed correctly.
• Check cable routing to make sure cables are not damaged or creating a safety hazard.
• Ensure all equipment is mounted properly and securely.

Step 4: Connecting Devices to the Switch

The following procedure describes how to connect PCs to the switch's RJ-45 ports. The GS110TP
Smart PoE Switch contains Auto Uplink technology, which allows the attaching of devices using
either straight-through or crossover cables.
Link/Act Mode
Green Link at 1000M
=
Yellow Link at 100M/10M
=
PoE Max
Blink
PoE Mode
Green PoE Powered
=
Yellow PoE Fault
=
Desktop PC
Figure 4-1
Installation
Link/Act PoE
ACT
=
PoE
Ports
v1.0, March 2010
GS110TP Hardware Installation Guide
Link/Act
Desktop PC
P S GS110TP
9F 10F
Link/Act
4-3