Installing The Unit; Removing The Unit - Kenwood DMX7022S Instruction Manual

Installation and Connection Installation and Connection
Installation procedure
1
Remove the key from the ignition and
disconnect the battery.
·
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wires of the wiring harness
in the following order: ground, battery,
ignition.
5
Connect the wiring harness to the unit.
6
Install the unit in your car.
Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (e.g., the
sound may skip).
7
Reconnect the battery.
·
8
Initialise the unit (page 39).
9
Configure <Initial Setup> (page 4).
44 ENGLISH

Installing the unit

Installing the unit using the mounting
bracket removed from the car
π / [
Note: Select the appropriate screws (supplied) for the
mounting bracket.
* Shape of your car brackets may differ.
Installing the unit using the mounting
sleeve
'
Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
Installing the trim plate
π / [
Car bracket*

Removing the unit

1
Remove the trim plate (
two extraction keys (
\
]
] ) by inserting the
\ ) as illustrated.
]