Removing The Unit; Installing The Unit - Kenwood DMX100 Instruction Manual

Installation

Installing the unit

✎
NOTE
• Make sure that the unit is installed securely in place. If
the unit is unstable, it may malfunction (eg, the sound
may skip).
Ñ Trim plate
1) Attach accessory 1 to the unit.
Ñ Removing the trim plate
1) Use the extraction key (accessory 3) to lever out the
four tabs (two on the upper part, two on the lower
part).
2) Pull the trim plate forward.
14
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it in
place.
1
3
Ñ Removing the unit
1) Remove the trim plate by referring to step 1 in
"Removing the trim plate".
2) Insert the two extraction key (accessory 2) deeply
into the slots on each side, as shown. (The protrusion
at the tip of the extraction key must face toward the
unit.)
3) Pull out the unit halfway.
✎
NOTE
• Be careful to avoid injury from the catch pins on the
extraction key.
4) Pull the unit all the way out with your hands, being
careful not to drop it.
2