Installing The Rops Pivot Shoulder Bolts; Installing The Weights - Toro Z Master 4000 Series Operator's Manual

2
Installing the ROPS Pivot
Shoulder Bolts
Parts needed for this procedure:
2 Shoulder bolt
2 Wave washer
2
Locknut (1/2 inch)
Procedure
1. Secure the shoulder bolt to the roll bar using a
wave washer and locknut (1/2 inch) as shown
in Figure 6.
2. Repeat this procedure on the other side.
1. Locknut (1/2 inch)
2. Wave washer
Figure 6
3. Shoulder bolt
3

Installing the Weights

Parts needed for this procedure:
2 12.5 lb weight plate (60-inch machines only)
Carriage bolt (3/8 x 2-1/2 inches)—60-inch machines
4
only
Hex-socket flange nut (3/8 inch)—60-inch machines
4
only
2 Caster weight
8 Carriage bolt (3/8 x 1 inch)
8 Flange nut (3/8 inch)
1 Weight bracket assembly
2 Suitcase weight
2 Locknut (3/8 inch)
2 Carriage bolt (3/8 x 5 inches)
g341473
9