Installing The Hopper Assembly - Toro Z Master 4000 Series Operator's Manual

3. Secure the pivot mount and left upper bracket to
the left, rear guard and bagger support using 2
hex-head bolts (5/16 x 3-1/4 inches), 2 washers,
2 locknuts (5/16 inch), 1 hex-head bolt (3/8 x
1-1/4 inches), and 1 locknut (3/8 inch) as shown
in Figure 13.
Figure 13
Left side shown
1. Hex-head bolt (5/16 x
3-1/4 inches)
2. Washer
3. Pivot mount
4. Left upper bracket
4. Secure the right upper bracket to the right, rear
guard and bagger support using 2 hex-head
bolts (5/16 x 3-1/4 inches), 2 washers, 2 locknuts
(5/16 inch), 1 hex-head bolt (3/8 x 1-1/4 inches),
and 1 locknut (3/8 inch) as shown in
g375902
5. Locknut (5/16 inch)
6. Locknut (3/8 inch)
7. Hex-head bolt (3/8 x 1-1/4
inches)
Figure 13.
5
Installing the Hopper
Assembly
Parts needed for this procedure:
1 Left lower support
1 Right lower support
2 Backer plate
4 Locknut (5/16 inch)
4 Carriage bolt (5/16 x 2-1/4 inches)
1 Locknut (3/8 inch)
1 Carriage bolt (3/8 x 7/8 inch)
1 Hopper assembly
2 Pin and hairpin cotter assembly
Procedure
1. Secure the left lower support to the machine
frame and pivot mount using 2 carriage bolts
(5/16 x 2-1/4 inches), 1 backer plate, 2 locknuts
(5/16 inch), 1 carriage bolt (3/8 x 7/8 inch), and
1 locknut (3/8 inch) as shown in
2. Secure the right lower support to the machine
frame using 2 carriage bolts (5/16 x 2-1/4
inches), 1 backer plater, and 2 locknuts (5/16
inch) as shown in
15
Figure 14.
Figure 14.