Zanussi ZDI14001 User Manual page 23

Warning! Deactivate the appliance before you make
the checks.
Problem
The programme does not
start.
The appliance does not fill
with water.
The appliance does not drain
the water.
After the checks are completed, activate the appliance. The
programme continues from the point of interruption.
If the problem occurs again, contact the Service.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Possible cause
The mains plug is not connected in the
mains socket.
The appliance door is open.
The fuse in the fuse box is damaged.
The delay start is set.
The water tap is closed.
The water pressure is too low.
The water tap is clogged or there is lime-
scale on it.
The filter in the water inlet hose is clog-
ged.
The water inlet hose has a kink or a
bend.
The anti-flood device is on. There are
water leakages in the appliance.
The sink spigot is clogged.
The water drain hose has a kink or a
bend.
Possible cause
The filters are clogged.
The filters are not correctly assembled
and installed.
The spray arms are clogged.
The programme was not applicable for
the type of load and soil.
Connect the mains plug.
Close the appliance door.
Replace the fuse.
Cancel the delay start or wait for the end
of the countdown.
Open the water tap.
Contact your local water authority.
Clean the water tap.
Clean the filter.
Make sure that the position of the hose is
correct.
Close the water tap and contact the Serv-
ice.
Clean the sink spigot.
Make sure that the position of the hose is
correct.
If the display shows other alarm codes, contact the Serv-
ice.
Clean the filters.
Make sure that the filters are correctly as-
sembled and installed.
Remove remaining soil with a thin pointed
object.
Make sure that the programme is applica-
ble for the type of load and soil.
Possible solution
Possible solution
23