Zanussi ZDI14001 User Manual page 18

German
degrees
(°dH)
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
Manual adjustment
1
E E lectronic adjustment
1. Press the on/off button to activate the appliance. The
on/off indicator comes on.
2. Make sure that the appliance is in setting mode. Refer
to 'SETTING AND STARTING A PROGRAMME'.
3. Press and hold function buttons (B B ) and (C C ) at the
same time until the indicators of function buttons (A A ),
(B B ) and (C C ) flash.
4. Press function button (A A ).
18
Water hardness
French mmol/l
degrees
(°fH)
91 - 125 9.1 - 12.5
76 - 90 7.6 - 9.0
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
2
Turn the water hardness
dial to the position 1 or 2.
Clarke
degrees
64 - 88
53 - 63
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
• The indicators of function buttons (B B ) and (C C ) go
off.
• The indicator of function button (A A ) continues to
flash.
• The end indicator flashes showing the setting of
the water softener.
– The number of flashes of the end indicator
shows the level of the water softener.
Example: 5 flashes + pause + 5 flashes = level
5.
5. Press function button (A A ) again and again to change
the setting. Each time you press function button (A A )
you go to the next level.
6. Deactivate the appliance to confirm.
Filling the salt container
Caution! Only use dishwasher salt. Other products
can cause damage to the appliance.
Water and salt can come out from the salt container when
you fill it. Risk of corrosion. To prevent it, after you fill the
salt container, start a programme.
Water softener
adjustment
Manual Electronic
10
1)
2
9
1)
2
1) 8
2
7
1)
2
6
1)
2
1) 1)
2 5
1 4
1 3
1 2
2) 2)
1 1