Output Shaft Speed Sensor Removal And Installation; Output Shaft Speed Sensor Inspection - Suzuki Grand Vitara 2011 Manual

5A-95 Automatic Transmission/Transaxle:
Output Shaft Speed Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Hoist vehicle.
3) Disconnect output shaft speed sensor connector.
4) Remove output shaft speed sensor (1) from
transmission.
Installation
1) Check that sensor is free from any metal particles
and damage.
2) Apply A/T fluid to new O-ring and then install output
shaft speed sensor (1) to transmission.
Tighten sensor bolt to specified torque.
Tightening torque
Output shaft speed sensor bolt (a): 7 N·m (0.7
kgf-m, 5.0 lb-ft)
3) Connect output shaft speed sensor connector.
4) Lower hoist.
5) Connect negative cable at battery.

Output Shaft Speed Sensor Inspection

1) Disconnect negative cable at battery.
S6JB0A5106017
2) Hoist vehicle.
3) Disconnect output shaft speed sensor connector.
4) Check output shaft speed sensor (1) for resistance
between terminals of sensor.
Output shaft speed sensor resistance
Standard: 560 – 680 Ω (at 20 °C (68 °F))
1
I5JB0A510048-01
1
(a)
I5JB0A510049-01
S6JB0A5106018
1
I5JB0A510050-01