Reading The Alarms; Rapid Reading Of Alarms; Deleting The Last Alarm - Electrolux Inspiration EWX11831 TC4 Service Manual

4.4.2 Reading the alarms

The last three alarms stored in the FLASH memory of the PCB can be displayed:

enter the diagnostic mode (para. 4.1)

Irrespective of the type of PCB and configuration, turn the programme selector knob
clockwise to the eleventh position and the last alarm is displayed.

to display previous alarms, touch the sensor closest to the START/PAUSE sensor in
sequence (as shown in the figure)

To return to the last alarm, touch the START/PAUSE sensor.

4.4.3 Rapid reading of alarms

The last alarm can be displayed even if the programme selector is not in the eleventh position (diagnostics)
or if the appliance is in normal operating mode (e.g. during the execution of the washing programme):
→ Touch the START/PAUSE sensor and the nearest option sensor simultaneously (as if you were
entering DIAGNOSTIC mode) and hold for at least 2 seconds: the LCD display shows the last alarm.
→ The alarm will continue to be displayed until a sensor is touched.
→ While the alarm is being displayed, the appliance continues to perform the cycle or, if in the programme
selection phase, it stores the previously selected options.

4.4.4 Deleting the last alarm

It is good practice to cancel the alarms stored:

after reading the alarm codes, to check whether the alarm re-occurs during the diagnostic cycle

after repairing the appliance, to check whether it re-occurs during testing
1. enter the diagnostic mode (para. 4.1)
2. Turn the selector clockwise until the eleventh LED lights up.
3. Simultaneously press the START/PAUSE sensor and the nearest option sensor
(as shown in the diagram).
4. Keep your fingers over the sensors until the LCD display shows "E00" (at least
5 seconds).
N.B. With this operation all the alarms stored are deleted.
2013 TS/DT-mdm FCPD-dp
Guide to diagnostics of EWX11831 electronic controls
TC 4
TC 4
TC 3
13/71
TC4
TC3 - TC2
TC 3
599 77 00-82 Rev. 01