Advertisement
MWTK-60
24" / 60cm Stainless Steel Trim Kit
VOID CUT-OUT
1.
Unscrew the 4 screws holding the 2 pieces of wood in place, and retain the screws
2.
Hold the MWTK-60 in place and position the 2 pieces of wood against the cabinet sides and against the MWTK.
Remove the MWTK
3.
Screw the 2 pieces of wood onto the base of the cabinet. The wooden strips should touch the inside of the front
of the MWTK-60, and be aligned against the side gables.
(wooden stripes 18"= 46cm apart)
4.
Being careful not to scratch the microwave door, lift the microwave onto the wooden strips, and move it back
about 2 inches.
5.
Place the MWTK-60 into position. Use the 4 screws and screw them through the flanges into the side gables.
6.
Pull the microwave forward, and align the front of the microwave with the front of the MWTK-60
7.
To stop the microwave from sliding backwards whilst opening it, it might be necessary to attach a piece of wood
behind the feet of the microwave, on the wooden supports
8.
Air must be able to flow from the microwave upwards and into the room, or roof space. Failure to comply will
void the manufacturer's warranty on the micro wave oven.
Specifications are subject to change without notice
V1.0
Advertisement
