Advertisement
MWTK-60
24" / 60cm Stainless Steel Trim Kit
1. Unscrew the 4 screws holding the 2 pieces of wood in place, and retain
the screws
2. Hold the MWTK-60 in place and position the 2 pieces of wood against the
cabinet sides and against the MWTK. Remove the MWTK
3. Screw the 2 pieces of wood onto the base of the cabinet. The wooden
strips should touch the inside of the front of the
MWTK-60, and be aligned against the side gables.
(wooden stripes 18"= 46cm apart)
4. Being careful not to scratch the microwave door, lift the microwave onto
the wooden strips, and move it back about 2 inches.
5. Place the MWTK-60 into position. Use the 4 screws and screw them
through the flanges into the side gables.
6. Pull the microwave forward, and align the front of the microwave with
the front of the MWTK-60
7. To stop the microwave from sliding backwards whilst opening it, it might
be necessary to attach a piece of wood behind the feet of the microwave,
on the wooden supports
8. Air must be able to flow from the microwave upwards and into the room,
or roof space. Failure to comply will void the manufacturer's warranty on
the micro wave oven.
Specifications are subject to change without notice
V1.0
Advertisement
