Bosch Active Line Owner's Manual page 27

Operation
Initial Operation
 Use only original Bosch battery packs approved for
your eBike by the manufacturer and purchased from
a trusted source. Use of non-approved or counterfeit
battery packs can lead to death or serious injury.
Switching On and Off
Switching the battery pack on is one of the ways of starting
the eBike system. Read and follow the operating instruc-
tions for the drive unit and the on-board computer.
Before switching on the battery pack or the eBike system,
check that the lock A6 is locked.
To switch on the battery pack, press the On/Off button A4.
The LEDs for indicator A3 light up and, at the same time, in-
dicate the charge condition.
 Always check that the battery pack is locked in
place. To do this, pull on the battery pack handle (after
the key has been removed).
Note: When the battery pack capacity is below 5 %, none of
the LEDs for charge-control indicator A3 will light up. Only
the on-board computer will indicate if the eBike system is
switched on.
To switch off the battery pack, press the On/Off button A4
again. The LEDs for indicator A3 go out. This also switches
off the eBike system.
When no power output from the eBike drive unit is request-
ed for approx. 10 minutes (e. g., because the eBike is
parked) and no button for the drive on-board computer or
operating unit is pressed, then the eBike system, and thus
the battery pack, automatically switches off to save energy.
The battery pack is protected against deep discharging,
overcharging, overheating and short-circuiting by the
"Electronic Cell Protection (ECP)". In case of hazardous sit-
uations, a protective circuit automatically switches off the
battery pack.
When a defect in the battery pack is
detected, two LEDs for the charge-con-
trol indicator A3 flash. In this case,
please contact an authorized Bosch
eBike dealer.
Bosch eBike Systems
English–27
0 276 001 USAen | (17.6.15)