Others; Replacement Parts - Hitachi R-C6800S How To Use Manual

TROUBLESHOOTING/REPLACEMENT PARTS
When this happens

Others

You feel electricity a little when touching
● The refrigerator may be charged with static electricity, but there is no problem with the safety.
the main body of the refrigerator → It is recommended to ground if you want to remove it.
● It is caused by the electromagnetic radiation slightly generated from this refrigerator.
Radio and/or television
→ Install the refrigerator away from the television, radio and interphone.
→ It is recommended to connect the power plug to the power outlet separated from the antenna terminal and
are disturbed by noises
● Those lines are caused by the liquid resin fl owing when plastic is molded.
There are thin lines like
scratches on the plastic parts
There are waving and/or distortions
● Slight waving and/or distortions are generated in the manufacturing process of the refrigerator.
on the door surface, the side and the
top surface of the refrigerator.
● Approximately two minutes after the end of operation, indicator lamps, excluding FREEZER , REFRIGERATOR , ENERGY SAVING ,
The Control Panel is unlit.
The magnet does not adhere to the door
● The magnet does not adhere because the door is made of glass.
There is a small hole
● This hole is used to escape the air inside when fi lling the heat insulation material into the
inside the door
● Reduce the number of times of opening and closing the door and avoid storing food additionally until the electric supply is restored.
The electric supply failed
The refrigerator is not expected
● Unplug the power plug and maintain the inner of the refrigerator and the Automatic Ice Maker, and leave all
to use for a long term
When no ice-making is required
● Any operation to remove frost is not required because this refrigerator remove frost automatically.
Remove frost
Transporting and moving care
● A lower setting of the condensation prevention heater will reduce power consumption.
When you want
to lower the
setting of the
● The setting will be cancelled when the power plug is connected and disconnected or power failure recovery takes place.
condensation
● Setting the swing partition
prevention
1. Open the Lower Freezer Compartment.
heater (the swing
2. Press and hold the
partition and the
3. Repeat the procedure provided in Step 2 to change Energy Saving level further.
partitioning iron
4. Close the Lower Freezer Compartment.
plates)
1. Open the door of the Lower Freezer Compartment.
2. With the door of the Refrigerator Compartment closed, touch and hold the
Swing
partition
3. Repeat the procedure provided in Step 2 to change Energy Saving level further.
4. Close the door of the Lower Freezer Compartment.
Partitioning
To cancel the setting, perform the same operations at Level 1 and 2 under the state of Level 4.
iron plates
Alarm is raised (two beeps sound) to cancel the setting.
Temperature settings for Refrigerator and Freezer Compartments can be adjusted
by nine levels, more fi nely than the three levels: MIN. , MID. and MAX. .
1. Open the Lower Freezer Compartment.
When you want
2. Touch and hold the
to adjust the
3. Close a door of the Lower Freezer Compartment.
temperature
4. Adjust the
more fi nely
5. If you want to stop the fi ne adjustment, perform the operation of 1 and 2.

REPLACEMENT PARTS

When replacing the following parts, make sure to tell your dealer the type name and buy the special parts.
Replacing the water fi lter
● Replace the water fi lter when it becomes old.
(Replace it normally once 3 〜 4 years.)
● Ordering the replacement water fi lter
Tell your dealer the parts number: RJK-30 to buy the replacement water
fi lter. (Ice making capacity is the same with the water fi lter removed.)
ground the refrigerator. Pg.37
They are especially conspicuous for the transparent parts, but there is no problem with the strength and they
can never lead to any cracks.
They may be conspicuous according to the position of the light source and/or the brightness etc., but there is
no problem with the performance.
QUICK , WATER and eco Operation , become unlit for energy saves.
door during the production process. It is neither a fl aw nor abnormal thing.
Please check each setting on the panel for operation after the power comes back on.
the door open to dry the refrigerator for 2 〜 3 days.
See Not making ice (Stop Ice Making) .
Thawed water is collected in the evaporating tray and automatically evaporates.
See Transporting your refrigerator (transport for moving)
The setting of a heater for dew condensation prevention has four levels. The level 4 achieves the highest reduction in power consumption.
A lower setting of the condensation prevention heater may cause dew condensation in the swing partition or the partitioning iron plates when humidity is high.
When dew is formed, cancel the setting.
button on the Control Panel with the refrigerator
doors closed for three seconds or more until one long beep sounds. (Level 1)
Setting the partition plate
on the control panel for 3 seconds or longer until one long beep sounds (Level 1).
Level 1 for saving electricity Level 2 for saving electricity
button on the Control Panel for fi ve seconds or
more until one beep sounds (This allows fi ner adjustment.)
or button to make an adjustment. The temperature
becomes higher by one level every time you touch the button. (Touching
MAX. returns to MIN. .)
Two beeps sound and you can set the temperature by normal step.
Please check. This is the cause.
Pg.37
Pg.43, 49, 51〜53
Pg.46
Pg.37
Level 3 for saving electricity
Replacement of the vacuum packing
● If vacuum state can no longer be maintained due to damage,
deformation or a change in color, please replace it with a new one.
● Part number for each refrigerator model
Type: R-C6800S, R-C6800H, R-C6800M, R-C6800N, R-C6800A
R-C6200S, R-C6200H
Hole (inside of the door)
Touch this button for more than 3 seconds
button
Touch this button for more than 3 seconds
Level 4 for saving electricity Deactivate
Lighting
MAX.
MID.
MIN.
MIN MID
Temperature setting
Parts number
R-B6700 311
R-A6200 321
About 3
seconds
About 3
seconds
Blinking
MAX
57