Makita XOB02 Instruction Manual page 11

Installing and removing dust bag
Optional accessory
Attach the dust bag over the tapered dust spout at the
back end of the motor housing. Put the dust inlet of the
bag onto the dust spout as far as it will go to avoid it
from coming off during operation.
Fig.21
► 1. Dust spout 2. Dust inlet 3. Dust bag
NOTICE:
Do not hold the dust bag when carry-
ing the tool. Otherwise, the tool may fall and be
damaged.
NOTE: To ensure optimal dust collecting, empty the
dust bag when it becomes filled to approximately half
of its capacity.
Remove the dust bag from the tool and remove the
dust nozzle. Then gently shake or tap the dust bag
to empty.
Fig.22
► 1. Dust nozzle
1
2
1
Installing and removing dust box
Optional accessory
Attach the dust box over the tapered dust spout at the
back end of the motor housing. Put the dust inlet onto
the dust spout as far as it will go to avoid it from coming
off during operation.
3
Fig.23
► 1. Dust spout 2. Dust inlet 3. Dust nozzle 4. Dust box
NOTICE:
Do not hold the dust box when carry-
ing the tool. Otherwise, the tool may fall and be
damaged.
NOTE: To ensure optimal dust collecting, empty the dust box
when it becomes filled to approximately half of its capacity.
1. Remove the dust box from the tool.
2. Detach the dust nozzle from the box while
pressing and holding the locking latches on both
sides of the box.
3. Gently shake or tap the dust box to empty.
Replacing paper filter
NOTICE:
Be aware to align the logos on all the
dust box, paper filter and dust nozzle in a consis-
tent orientation when reassembling components.
1. Remove the dust box from the tool.
2. Detach the dust nozzle from the box while pressing
and holding the locking latches on both sides of the box.
1
Fig.24
► 1. Dust nozzle 2. Dust box 3. Locking latch
3. Hold the inner top edge of the cardboard opening,
and pull it off downwards to disengage the outer top
edge of the cardboard opening from the upper hooking
tab on the lip of the dust box.
11 ENGLISH
1
2
3
2
3
4
3