Table of Contents
Advertisement
dot1x timeout supp-timeout
The dot1x timeout supp-timeout Interface Configuration mode command sets the time for the retransmission of
an Extensible Authentication Protocol (EAP)-request frame to the client. To restore the default configuration, use
the no form of this command.
Syntax
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
Parameters
•
seconds — Time in seconds that the device waits for a response to an EAP-request frame from the client
before resending the request. (Range: 1-65535 seconds)
Default Configuration
Default timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust for unusual circumstances, such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
Example
The following example sets the timeout period before retransmitting an EAP-request frame to the client to 3600
seconds.
Console(config)# interface ethernet 1/16
Console(config-if)# dot1x timeout supp-timeout 3600
Page 458
802.1x Commands
dot1x timeout supp-timeout
Advertisement
Table of Contents
