Makita LT02R1 Manual

Cordless angle impact driver / cordless angle impact wrench

Advertisement

Quick Links

MANUAL
Cordless Angle Impact Driver /
Cordless Angle Impact Wrench
LT01 / LT02
Read before use.

Advertisement

Table of Contents
loading

Summary of Contents for Makita LT02R1

  • Page 1 MANUAL Cordless Angle Impact Driver / Cordless Angle Impact Wrench LT01 / LT02 Read before use.
  • Page 2: Specifications

    (Original instructions) SPECIFICATIONS Model: LT01 Fastening capacities Machine screw 4 mm - 8 mm (5/32" - 5/16") Standard bolt M4 - M12 (5/32" - 1/2") High tensile bolt M4 - M8 (5/32" - 5/16") No load speed 0 - 2,000 /min Impacts per minute 0 - 3,000 /min Maximum fastening torque...
  • Page 3 Do not expose power tools to rain or wet con- Do not use the power tool if the switch does ditions. Water entering a power tool will increase not turn it on and off. Any power tool that cannot the risk of electric shock. be controlled with the switch is dangerous and must be repaired.
  • Page 4 Do not expose a battery pack or tool to fire or Cordless impact wrench safety excessive temperature. Exposure to fire or tem- warnings perature above 130 °C may cause explosion. Follow all charging instructions and do not Hold the power tool by insulated gripping charge the battery pack or tool outside the surfaces, when performing an operation temperature range specified in the instruc-...
  • Page 5: Functional Description

    It will also void the Makita warranty for the Makita tool and To install the battery cartridge, align the tongue on the charger.
  • Page 6 Overloaded: Switch action The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, turn the tool off and stop the application that caused the tool to become overloaded. Then turn the tool on to restart. If the tool does not start, the battery is overheated.
  • Page 7: Installing Hook

    Reversing switch action NOTE: If the driver bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the driver bit will not be secured. In this case, try re-inserting the bit according to the instruc- tions above.
  • Page 8: Operation

    Ratchet head Adjusting the angle head The angle head can be adjusted 360°(8 positions in 45-degree increments). Loosen the hex bolt and remove the angle head. OPERATION ► 1. Angle head 2. Hex bolt CAUTION: Always insert the battery cartridge Adjust the angle head to the desired position and all the way until it locks in place.
  • Page 9 High tensile bolt NOTE: Use the proper bit for the head of the screw/ bolt that you wish to use. NOTE: Hold the tool pointed straight at the screw. (ft lbs) NOTE: If the impact force is too strong or you tighten the screw for a time longer than shown in the figures, (29) the screw or the point of the driver bit may be over-...
  • Page 10: Maintenance

    Discoloration, deformation or cracks may result. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. OPTIONAL ACCESSORIES CAUTION:...

This manual is also suitable for:

Lt02Lt01

Table of Contents