Troubleshooting - Black & Decker BIMH226W Instruction Manual

TROUBLESHOOTING & WARRANTY
Troubleshoot your problem by using the chart below. If the unit still does not
work properly, contact BLACK+DECKER customer service center or the nearest
authorized service center.
WARNING: Users must never troubleshoot internal components.
TROUBLE
"ADD WATER" indicator is
on.
"ICE FULL" indicator is
on.
Ice cubes stick together.
Ice making cycle is
normal but no ice formed.
Page 12
POSSIBLE CAUSE
Lack of Water.
Ice is full in basket.
The ice making cycle is too
long.
Water temperature in inner
tank is too low.
Room temperature or water
temperature in inner tank is
too high.
Refrigerant in cooling system
leaks.
Pipe in the cooling system is
blocked.
POSSIBLE REMEDY
Stop the ice maker, fill water,
and press "ON/OFF" button
again to restart the unit.
Remove ice from ice basket.
Press "Select" button for 5
seconds, the unit can make
10 more ice cycles when "Ice"
indicator is on.
Stop the ice maker, and
restart it when the ice blocks
melt. Select the small size ice
cube selection.
Replace the water.
Temperature of water
recommended at 40°F-90°F.
The room temperature
should be 50°F-105°F, water
temperature should be
40°F-90°F.
Verify by a qualified
technician.
Verify by a qualified
technician.