Cleaning & Care; Cleaning And Maintenance - Black & Decker BIMH226W Instruction Manual

SET UP & USE
Ice Full Indicator Light
The ice maker stops when the ice basket is full. The "ICE FULL"
on. Use the scoop to remove the ice.
Water Shortage Indicator Light
If there is not enough water, the ice maker will stop automatically, and the WATER
SHORTAGE indicator light will go on. Press "ON/OFF"
the max. water level mark and press "ON/OFF"
again.
NOTE: Wait at least 3 minutes before restarting the unit.
CLEANING & CARE

CLEANING AND MAINTENANCE

WARNING: Before using your ice maker, it is recommended to clean it thoroughly.
Always make sure the ice maker is unplugged prior to cleaning.
1. Remove the ice basket.
2. Clean the interior with a mild soap and water solution and a soft sponge or cloth.
3. Rinse all interior parts.
4. Rinse and drain any remaining water by unplugging the drain cap located on the
front of the base.
5. The outside of the ice maker should be cleaned regularly with a mild detergent
solution and warm water.
6. Dry the interior and exterior with a clean soft cloth.
7. When the machine is not to be used for a long time, drain water completely &
dry the interior.
Self-cleaning function:
The unit is equipped with a self cleaning function. It is recommended to use equal
parts white vinegar and water with this function. Press and hold the "ON/OFF" button
for 5 seconds to activate self-cleaning. The function will take 30 minutes. When
the program is complete, rinse with clear water and drain, making sure the vinegar
solution is removed before making ice. Dry thoroughly.
Page 10
indicator will be
button, fill water up to
button again to turn on the unit