Preparation; Requirements - Siemens SIMATIC S7-300 Getting Started

Preparation

2.1

Requirements

Requirements
The following requirements must be fulfilled:
● An S7-300 station, consisting of:
● A PG/PC with MPI interface and properly installed software packages and commissioning
● The PG/PC is connected to the CPU via the MPI/DP interface (transmission rate up to
● A SIMODRIVE 611U is interconnected with the CPU 317T-2 DP via DP(DRIVE) interface.
● The SIMODRIVE 611U modules:
CPU 317T-2 DP: Controlling a physical axis
Getting Started, 03/2008, A5E00251786-05
– Power supply (PS), e.g. 6ES7 307-1KA00-0AA0
– CPU 317T-2DP with inserted MMC (4 MB or more).
– Optional digital input module (DI) with bus connector, for example,
6ES7 321-1BH02-0AA0
– Optional digital output module (DO) with bus connector, for example,
6ES7 322-1BH01-0AA0
– Two optional front connectors for the digital modules
tools as listed below:
– STEP 7 as of V5.4 SP2
– S7 Technology as of V4.1
– SimoCom U (Version 10.03.03 or higher)
12 Mbps; default 187.5 kbps):
– PROFIBUS cable 6ES7901-4BD00-0XA0 (for transmission rates up to 12 Mbps)
– Controller module, for example, 6SN1 118-0NH00-0AAx
– Optional Motion Control module with PROFIBUS DP, 6SN1 114-0NB01-0AA0
– Also required for operating the SIMODRIVE 611U:
– A power unit, for example, 6SN1 12x-1Ax0x-0HAx
– A motor, for example, 1FT6 031-xAK7x-xExx (rated speed 6000 rpm), for example,
with one absolute value encoder
2
7