Cisco WAE-INLN-4CG Series Manual page 22

Installing Adapters in the WAE-7371, WAE-7341, and WAE-674 Appliances
Installing Adapters in the WAE-7371, WAE-7341, and WAE-674
Appliances
Removing the Cover
Warning
Step 1
Step 2
Step 3
Step 4
Installing the Cisco WAE Inline Network Adapter
22
Get user manuals: See SafeManuals.com
This section describes how to install the inline network adapter in the WAE-7371, 7341, and 674
appliances. This section includes the following procedures:
• Removing the Cover
Installing an Inline Network Adapter
•
Completing the Installation
•
Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.
Statement 1
To remove the device top cover, follow these steps:
Review the information in the
Power off the device and all attached devices and disconnect all external cables and power cords.
Press down on both side latches and pull the device out of the rack enclosure until both slide rails lock.
You can reach the cables on the back of the device when the device is in the locked position.
Note
Lift the cover-release latch (see
Figure 15 Removing the Cover
Cover-release latch
"Safety Guidelines" section on page
Figure 15). Lift the cover off the device and set the cover aside.
5.
OL-12480-03