Cisco WAE-INLN-4CG Series Manual page 14

Installing Adapters in the WAE-512 and WAE-612 Appliances
Caution
Installing an Inline Network Adapter
Caution
Note
Step 1
Step 2
Step 3
Step 4
Step 5
Installing the Cisco WAE Inline Network Adapter
14
Get user manuals: See SafeManuals.com
For proper cooling and airflow, replace the cover before turning on the device. Operating the device for
extended periods (over 30 minutes) with the cover removed might damage device components.
Before you install adapters, review the following information:
• The adapter slots are on the riser card assembly. You must first remove the riser card assembly to
access the adapter slots. (See
• The device has two Peripheral Component Interconnect-Extended (PCI-X) adapter slots:
PCI-X slot 1 is for one full-height three-quarter-length adapter.
–
PCI-X slot 2 is for one low-profile half-length adapter; however, it is not used in this device.
–
• You must install supported adapters in PCI-X slot 1. (This slot is labeled "Slot 1" on the back of the
device.)
When you handle static-sensitive devices, take precautions to avoid damage from static electricity. For
details on handling these devices, see the
page 7.
The illustrations in this document might differ slightly from your hardware.
To install an adapter, follow these steps:
Review the safety information in the
Power down the device and peripheral devices.
Disconnect the power cord and then all external cables from the device.
Remove the device cover.
Grasp the riser card at the rear edge and lift to remove the riser card assembly. (See
Figure 8.)
"Protecting Against Electrostatic Discharge" section on
"Safety Guidelines" section on page 5.
Figure 8.)
OL-12480-03