Linksys PPS1UW User Manual page 21

IPP Client Configuration for Windows 95, 98, Millennium, NT 4.0, 2000,
and XP
1. Run the Add IPP Port program entry created by the installation. A screen
like the one shown in Figure 8-1 will be displayed.
2. If Internet access from your location is via a Proxy Server, check Access IPP
Server via Proxy Server, and enter details of your Proxy Server. (This will
be the same as your Browser configuration.)
3. Enter the IP Address or URL of the IPP Server.
4. Click Select Device Port to view the available ports on the IPP Server, and
select the appropriate port. A connection to the IPP Server will be estab-
lished at this time.
35
Instant EtherFast
Figure 8-1
® Series
EtherFast ® Wireless-Ready USB PrintServer
Note: Verify that USB 1 appears in the field beside the Select Device
Port button. If it does not, click the Select Device Port button, and
select USB 1.
5. Click Save to create the IPP port on your system. You will see a message
confirming that the port has been created and then Figure 8-2.
6. Perform one of these steps. Select an existing printer to use the new port, and
click OK.
Click the Add New Printer button to create a new printer to use the IPP
port. This will start the Add Printer Wizard. Follow the prompts to complete
the process. Make sure that the new printer uses the IPP port.
· To create additional IPP ports, repeat the entire procedure.
· The Proxy Server and other options are set individually for each IPP Port.
Changing the IPP Port Settings
After the IPP port is created, you can reach the Configure IPP Port screen by
performing these steps:
Figure 8-2
OR
Installation is now complete.
36