Network Storage Link for USB 2.0 Disk Drives
Administration Tab
System
From the System screen, you will be able to change some of the Storage Link's general and IP settings. These
settings, broken up into four categories, are as follows:
Identification
Server Name. In this field, you can enter a new Server Name for the Storage Link. Punctuation and other special
characters (e.g. * / | \ ) cannot be used in the name.
Comment. This field can be used to enter a comment, such as the Storage Link's location.
WorkGroup. This should match your networked PC's "Workgroup Name". If the Workgroup name does not match,
access to the Storage Link is still possible, but the Storage Link will not appear when you click the Browse
Network button (for example, when adding a Network Printer).
Location
Language Support. Select the appropriate language for users on your network. If multiple languages are used,
select the most common.
Time Zone. Select your local time zone.
Local Date. Enter today's date. The Storage Link will set its own calendar according to the date you provide.
Local Time. Enter the present time. The Storage Link will set its own clock according to the time you provide.
Figure 6-5: Administration Tab - System
Remember that this is not sent to the Server until you click the Save button.
WINS
Enable WINS. If your network has a WINS Server, check this to register the Storage Link with the WINS Server.
This will allow network users to locate this device through a Router. (Without WINS, "Network Neighborhood" or
"My Network Places" it only scans the local network segment.)
WINS Server. When enabling WINS, enter your WINS Server's IP Address in this field. Normally, this will be a
Windows NT/2000/XP Server.
Chapter 6: Configuring the Storage Link
17
Administration Tab