Advertisement
2
Base Mounting Bracket Assembly
You can mount the Antenna to a
base (such as a wall) or to a pole.
Before you do this, you will need
to assemble the mounting
bracket. The small page of
mounting hardware should be all
you need for either a base or pole
mounting.
If you are mounting the Antenna
to a base (not included), make
sure the base is secure. Follow the
assembly instructions below to
assemble the mounting bracket.
1
Antenna
1 pc
2
Sticker
1 pc
3
Plastics fixings
4 pcs
4
Holder
1 pc
5
Washers
4 pcs
6
Screws
4 pcs
Pole Mounting Bracket Assembly
If you are mounting the Antenna
to a pole, follow the instructions
2
below to assemble the bracket
and then insert the pole (not
included) into the mounting
bracket assembly.
1
Antenna
1 pc
2
Hose clamp
2 pcs
3
Holder
1 pcs
4
Washers
4 pcs
5
Screw nuts
4 pcs
Congratulations!
The connection is complete. You can
now begin using the Antenna.
For more detailed information, see
the User Guide contained on the
CD-ROM.
For additional information or troubleshooting help, refer to the User Guide on the Setup CD-ROM. You
can also email for further support.
Website
http://www.linksys.com or
http://www.linksys.com/international
Linksys is a registered trademark or trademark of Cisco Systems, Inc. and/or its affiliates in the U.S. and
certain other countries. Copyright © 2006 Cisco Systems, Inc. All rights reserved.
HGA9N-QI-60828NC SW
Advertisement
