Front Panel - Linksys EFR240 User Manual

Printer Port The Printer Port is where you can connect the
Instant RAID to your printer using a printer cable.
Uplink Button When connecting directly to a computer via
Ethernet, this button should be depressed.
For normal operation (connecting to a hub or
switch), this button should be UP.
LAN Port Use this port to connect the Instant RAID to your
10BaseT or 100BaseTX hub or switch.
100BaseTX LED indicator
This LED will glow amber if the LAN Port is
using 100BaseTX.
10BaseT LED indicator
This LED will glow green if the LAN Port is using
10BaseT.
4
Linksys EtherFast Series
®
Instant RAID

Front Panel

The Instant RAID has three LEDs for each disk, and six status LEDs.
RAID LEDs
Activity This LED flashes green when the disk is being
accessed.
Failure This LED is normally off. It will illuminate red if
the disk is not installed, or has failed.
Rebuilding This LED is normally off. When a new disk is
inserted, this LED will illuminate orange, indicat-
ing that data is being copied from the other disk. It
will continue to illuminate until the mirroring is
complete, then it will turn off.
Status LEDs
Ready This LED will illuminate when the Instant RAID
is on, will blink during startup or shutdown, and
will be off after the shutdown is complete.
Error
This LED is normally off. It will illuminate amber
during self-test, and turn off after the test is com-
plete. If it remains on, a hardware error is indicat-
ed.
During a software upgrade, both the Ready and
Error LEDs will blink.
5