Brother DCP-J1700DW Quick Setup Manual

Quick Setup Guide
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct installation procedure.
DCP-J1700DW
DCP-J1800DW
EN zh-TW
1
Unpack the machine and check the components
Remove the protective tape or film covering the machine and the supplies. The components included in the box may differ depending on your country.
• Most of the machine illustrations in this Quick Setup Guide show the DCP-J1800DW.
• The images in this guide are for illustration purposes only and may differ from the
actual products.
2
Load plain A4 paper in the paper tray
3
Connect the power cord
5
Install the inbox ink cartridges
6
Set the date and time
Follow the LCD instructions to set the date and time.
After setting the date and time, you can set the Firmware Update
defaults.
Video setup instructions:
support.brother.com/videos
1
Open the output paper tray
cover a.
NOTE
You can adjust the control panel angle
to read the LCD more easily.
Open the ink cartridge cover and remove
the orange protective part from the
machine.
NOTE
Do not throw away the orange protective part.
You will need it if you transport the machine.
The latest manuals are available at the Brother support website:
support.brother.com/manuals
NOTE
• Save all packing materials and the box in case you must ship your machine.
• You must purchase the correct interface cable for the interface you want to use.
USB cable
Use a USB 2.0 cable (Type A/B) that is no more than 2 metres long.
Ethernet (Network) cable
Use a straight-through Category 5 (or greater) twisted-pair cable for 10BASE-T or 100BASE-TX
Fast Ethernet Network.
After finishing the machine setup, you can change the paper type or size.
For more information about paper handling, see the Online User's Guide
at support.brother.com/manuals.
Adjust the paper guides.
Fan the paper well and load it
in the tray.
4
Select your country or language
After turning the machine on, you may need to set your country or language
(depending on your machine). If required, follow the LCD instructions.
Follow the LCD instructions to install the ink cartridges. Close
the ink cartridge cover. The machine will prepare the ink tube
system for printing.
NOTE
The first time you install a set of ink cartridges, the machine will use
an amount of ink to fill the ink delivery tubes for high-quality printouts.
This process will only happen once.
7
Check the print quality
Follow the LCD instructions,
and then press [OK]. The
machine prints the Print
Quality Check Sheet.
Close the output paper tray
Pull out the paper support a,
cover, and then slowly push and unfold the paper support
the tray completely into the flap b so that the printed
machine.
pages do not fall.
OK Poor
Follow the LCD instructions to
check the quality of the four
colour blocks on the sheet, and
then start the cleaning procedure
if required.
D02CPT001-00
ASA
Version 0
2
1