Replacement Of Eject Lever Of The Dvp-68 Board - Sony XVS-9000-C Service Manual

1-10.

Replacement of Eject Lever of the DVP-68 Board

Procedure
1. Remove the screw (P3 x 6).
2. Remove the screw (PSW3 x 6).
3. Remove the screw (PSW3 x 14), then remove the reinforcing plate L and eject lever.
4. Remove the reinforcing plate R and eject lever on the opposite side in the same procedure.
A
5. Install the removed parts by reversing the steps of removal.
Note
Push the plate nut F in the direction of the arrow (direction towards board) so that the convex portion of the eject
lever fits into the hole of the board, then tighten the set screw (PSW3 x 14) of the eject lever.
XVS-9000-C/XVS-8000-C/XVS-7000-C/XVS-6000-C
PSW
3 x 14
PSW
Reinforcing plate L
3 x 6
P3 x 6
Plate nut F
DVP-68 board
Eject lever
View on arrow A
Board
Hole of the board Convex portion of the
eject lever
Eject lever
Plate nut F
1-21