Additional Equipment; Quick Setup; Battery Installation - La Crosse Technology WS-7213U Instruction Manual

ADDITIONAL EQUIPMENT

(not included)
1.
1 Philips screwdriver.
2.
2 Fresh AA 1.5V batteries. (for the indoor weather station)
3.
2 Fresh AA 1.5V batteries. (for the temp/humidity sensor)

QUICK SETUP

Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries.
1. Have the indoor weather station and remote temp/humidity sensor 3 to 5 feet apart.
2. Batteries should be out of all units for 10 minutes.
3. Place the batteries into the remote temp/humidity sensor first, then into the indoor weather station.
(All remote temp/humidity sensors must be started before the indoor weather station)
4. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.
In this time the indoor weather station and remote temp/humidity sensor will start to talk to each other and the displays will show both the indoor
temperature and an outdoor temperature and humidity. If the indoor weather station do not display both the indoor temperature and the outdoor
temperature and humidity after the 15 minutes please retry the set up as shown on page five.
After both indoor temperature and outdoor temperature and humidity are displayed for 10 minutes you can place your remote temp/humidity sensor
outdoors and set your time.
Notes on Outdoor Sensor Placement
The remote temp/humidity sensor should be placed in a dry, shaded area. Fog and mist will not harm your remote temp/humidity sensor but direct
rain must be avoided.
The remote temp/humidity sensor has a range of 80 feet. Any walls that the signal will have to pass through will reduce distance. An outdoor wall or
window can have up to 30 feet of resistance and an interior wall can have up to 20 feet of resistance. Your distance plus resistance should not exceed
80 ft. in a straight line.
Notes on Weather Station Placement
The 80 ft distance is between each indoor weather station and the temp/humidity sensor independently. The placement of one indoor weather station
does not affect the placement of a second indoor weather station.
To complete the set up of your indoor weather station after the 10 minutes have passed, please follow the steps below.
1. Press and hold the "SET" button for five seconds.
2. The hour will now be flashing.
a. Press and release the "+" button until the correct hour is shown.
Note: There is "PM" displayed to the left of the hour when between noon and midnight. During the AM hours this area will be blank.
b. When the correct hour is shown, press and release the "SET" button once.
3. The minutes will now be flashing.
a. Press and release the "+" button until the correct minutes are displayed.
Press and release the SET button once more and you are done.
DETAILED SETUP GUIDE
I.

BATTERY INSTALLATION

A.
REMOTE TEMP/HUMIDITY SENSOR
Battery
compartment
1.
Remove the mounting bracket.
2.
Remove battery cover
3.
Observing the correct polarity, install 2 AA batteries—make sure they do not spring free, or start-up problems may occur.
Battery cover