Wireless 433 mhz wireless weather station (24 pages)
Summary of Contents for La Crosse Technology WS-7212U
Page 1
Figure 1 ADDITIONAL EQUIPMENT (not included) 1 Philips screwdriver. 4 Fresh AA 1.5V batteries. (2 for each indoor weather station) 2 Fresh AA 1.5V batteries. (for temp/humidity sensor) QUICK SETUP Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries.
Page 2
Observing the correct polarity, install 2 AA batteries. Replace battery cover. Wait 15 minutes or until both the indoor and outdoor temperatures are shown on the indoor weather station. The indoor weather stations should now show: “-:- -” in the TIME LCD, indoor temperature in the INDOOR LCD and outdoor temperature and humidity in the OUTDOOR LCD.
The WS-7212U is able to receive signals from 3 different remote temperature, temperature/humidity sensors. Following are some brief instructions for the basic set-up of remote sensor units with the WS-7212U. These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A...
Reattach the remote temp/humidity sensor to the mounting bracket. THE WEATHER STATION The indoor weather station comes with the table stand already mounted. If you wish to use the table-stand, all that is required is to place the indoor weather station in your desired location.
Page 5
The indoor sensor is less responsive to ambient air currents because of the shielding effect of the indoor weather station’s case. In addition, the casing can act as a heat sink to absorb and store heat from external sources (i.e. handling of the case or radiant heat).
• Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. • Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings. • Do not submerge in water.
La Crosse Technology provides a 1-year warranty on this weather station. Contact La Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the weather station in for repairs, contact La Crosse Technology. The weather station will be repaired or replaced with the same or similar model.