Table of Contents
Advertisement
FROST PRECAUTIONS
If the appliance is installed in an area where the
temperature can be less than 0° C, remove the
remaining water from the inlet hose and the drain
pump.
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
4. Empty the drain pump. Refer to the emergency
drain procedure.
CONSUMPTION VALUES
INTRODUCTION
See the web link www.theenergylabel.eu for detailed informa-
tion about Energy Label.
The QR code on the energy label supplied with the appliance pro-
vides a web link to the product information sheet. Keep the energy
label for reference together with the user manual and all other
documents provided with this appliance.
LEGEND
kg
Laundry load.
kWh
Energy consumption.
Litres
Water consumption.
%
Remaining moisture at the end of spinning phase. The higher is the spin speed, the higher is
the noise and the lower is the remaining moisture.
24
20°
5. When the drain pump is empty, install the inlet
hose again.
WARNING! Make sure that the
temperature is higher than 0 °C before
you use the appliance again.
The manufacturer is not responsible
for damages caused by low
temperatures.
hh:m
Programme duration.
m
°C
Temperature in the laundry.
rpm
Spin speed.
45°
Advertisement
Table of Contents
